CALIBRES 2403, 8421, 8806, 8807 (fig. VIII)
The crown has 2 positions:
1. Normal position (wearing position): when the crown is
positioned against the case, the crown ensures that the watch is
water-resistant.
Occasional winding: if the watch has not been worn for 40 hours
or more (50 for the calibre 8421 and 55 for the calibre 8806 and
8807), wind it up with the crown in position 1.
Calibres 2201 and 2211 (manual winding)
Winding: turn the crown forwards until it stops.
2. Time setting: hours – minutes. Pull the crown out to position 2.
Turn the crown forwards or backwards. Push the crown back to
position 1.
For calibres 2200, 2202, 2403, 8421, 8806 and 8807: syn
-
chronise the seconds by pushing the crown back to position 1
to coincide with a given time signal.
CALIBRES 2200, 2201, 2202, 2211 (fig. IX)
Manual & self-winding watch
Operating instructions2
To Next Page
Loading...
Need help?
General