Omega CALIBRE 1666 - MET Alarm Setup

/14
OMEGA SA WORLD SERVICE ORGANIZATION GT-19-C-069-E - A - 1666
Specifi c Information for calibre 1666
Fig. 2.5
Fig. 2.6
2.5 MISSION ELAPSED TIME (MT)
- Press P2 to add or P3 to subtract hours.
- Press P1, the day number (
DAYS
) blinks.
- Press P2 to add or P3 to subtract days.
- Push the crown back into position 1.
- Press P1 to start the timing.
The chronograph is stopped in several steps
- Pull the crown into position 2.
- Press P1 and
RESET ? is displayed.
- Push the crown into position 1.
The timing is stopped.
2.6 MISSION ELAPSED TIME ALARM (MA)
Description
This alarm rings once, for 15 seconds, at a specified
day and time. When the alarm rings, the MISSION
ELAPSED TIME ALARM (
MA
) function is displayed.
If the alarm ring is not stopped, a second alarm rings
one minute later for 15 seconds.
- Press the crown until
MA
is displayed.
- Push the crown during 3 seconds or pull it to
position 2. The seconds (
SEC
) blink.
- Press P2 to add or P3 to subtract seconds.
- Press P1, the minutes (
MIN
) blink. Press P2 to add or
P3 to subtract minutes.
- Press P1, the hours (
HOURS
) blink.
- Press P2 to add or P3 to subtract hours.
- Press P1, the day number (
DAYS
) blinks.
- Press P2 to add or P3 to subtract days.
- Push the crown back into position 1.
The MISSION ELAPSED TIME ALARM (
MA
) function
starts automatically.
- Press P1 for more than one second to set the alarm
(sound signal is heard) or to stop the alarm (
OF
is
displayed).
- Alarm ring : press P2 for more than 3 seconds to test
the sound of the alarm ring.