Why does air keep blowing out of my Omega ECD 15B Industrial Equipment?
If air keeps blowing out of your Omega Industrial Equipment, start by cleaning the valve, as it may be blocked. Also, replace any worn parts. Finally, check the system for intense corrosion.
How to troubleshoot no LED signal on Omega ECD 15B?
If there is no LED signal on your Omega Industrial Equipment, the issue might be a faulty or absent power supply, so check the power supply. Alternatively, the PCB could be defective, in which case you should replace the PCB.
What to do if pressing TEST button has no effect on Omega Industrial Equipment?
If pressing the TEST button on your Omega Industrial Equipment has no effect, it could be due to a blocked valve. Try cleaning the valve. Another possibility is that the system pressure is above 16bar / 232psi, so check the system pressure.
Why does condensate discharge only when TEST button is being pressed on Omega ECD 15B?
If condensate discharges from your Omega Industrial Equipment only when the TEST button is pressed, the installation may be faulty; verify that the device is installed according to recommendations. It could also be due to a condensate inlet line with an insufficient slope, so install a venting line. Finally, a very dirty sensor could be the cause; clean the sensor housing.
General| Model | ECD 15B |
|---|---|
| Category | Industrial Equipment |
| Manufacturer | Omega |
| Accuracy | ±1% of Full Scale |
| Display | LCD |
| Output | 4-20 mA |
| Conductivity Range | 0 to 2000 µS/cm |
| Resistivity Range | 0 to 20 MΩ·cm |
| TDS Range | 0 to 1000 ppm |
| Temperature Compensation | Automatic |
To Next Page