Omega ECD 15B - Troubleshooting; Warranty Exclusion

ECD 15B / 40B / 90B / 150B - Installation and operating manual
12
Trouble shooting
Problem
Possible cause
Solution
No LED signal

Faulty or no power supply

PCB defective

Check power supply

Replace PCB
Pressing TEST
button has no
effect

Blocked valve
 System pressure above 16bar /
232psi

Clean the valve
 Check system pressure
Condensate
discharge only
when TEST button
is being pressed

Faulty installation
 Condensate inlet line with
insufficient slope
 Sensor extremely dirty

Check if device is installed in
accordance with installation
recommendations
 Install venting line

Clean sensor housing
Air keeps blowing
out

Blocked valve
 Wear

Clean the valve
 Replace worn parts
 Check if intense corrosion is
present in the system
Permanent red LED
flashes

Device is in one of production
modes

Contact supplier
Warranty exclusion
The guarantee shall be void if:
 The installation and operating manual was not followed with respect to installation,
initial commissioning and maintenance.
 The unit was not operated properly and appropriately.
 The unit was operated when it was clearly defective.
 Non-original spare parts or replacement parts were used.
 The unit was not operated within the permissible technical parameters.
 Unauthorized constructional changes were made to the unit or if the unit has been
opened/disassembled by an unauthorized person.
OMEGA AIR d.o.o. Ljubljana
Cesta Dolomitskega odreda 10
SI-1000 Ljubljana, Slovenia
Tel.: +386 (0)1 200 68 00
Fax.: +386 (0)1 200 68 50
E-mail: info@omega-air.si
www.omega-air.si