Page - 3
This Booklet Contains
Introduction to the System ..................................................... 4-6
Status Light, Valet Switch, Controller & Transmitter
System Versatility - An Important Note......................................... 6
Using the Exclibur System ...................................................... 7
Arming Using the Controller or Transmitter .......................... 7-8
Arming Bypass, Sensor Bypass
Automatic “Last Door Arming” of the System ....................... 8-9
While the System is Armed, and should it Trigger ................. 9-10
Prewarning
Disarming the System Using the Controller or Transmitter ... 10-11
Safety Disarm Feature; Activation Alert; Automatic Rearming
Disarming By Emergency Override ........................................ 11-12
Remote Panic Feature.............................................................. 12
Other Controller and Transmitter Operations ......................... 13
Silent Arming & Disarming, Sensor Bypass;2nd, 3rd, 4th & 5th Channels
Using the Valet Switch ............................................................ 14-15
SecureCode.............................................................................. 15
The Status Light ...................................................................... 16
2-Way Controller..................................................................... 17-20
Icons & Programming
Anti-Carjacking Protection ..................................................... 21
Controller and Transmitter Protection .................................... 22
How to Program Controllers or Transmitters ......................... 22-23
Programmable Features List.................................................... 24
How to Program Features........................................................ 25-26
Programmable Features Descriptions ..................................... 26-34
Programmable Features Matrix ............................................... 35
Limited Lifetime Warranty .............................................. Back Cover
Feature #24 Factory Alarm Disarm Output Functions
Factory Default Setting Disarm Output
(press “arm/lock” button to program)
Options:
Horn Output (press “disarm/unlock” button to program)
Channel 5 Latch Output (press “II” button to program)
Channel 5 On Demand Output (press “III” button to program)
The default setting of this feature is to disarm the factory alarm when the
Excalibur is disarmed. Other options for this output are very popular application,
operating the vehicle’s existing horn; either in conjunction with the electronic
siren, or in place of the siren. Using both the siren and the horn creates an
extremely effective security system. The remaining options are Channel 5, with
the same operation parameters as described above for Channel 4, except that the
“disarm/unlock” and “III” buttons operate it, and Feature #21 can also change
this channel’s button assignment.
Note: Features #23 and #24 involve two outputs of the Excalibur control unit
which give the installer greater flexibility. These outputs can be programmed
to perform several different functions. The primary function, or default setting,
of these outputs are designed to be connected to the vehicle’s wiring so that
operating the Excalibur will cause the factory alarm to also arm and disarm.
But there are also several other functions of these two outputs which may be
programmed to operate, and more importantly, they must be configured by the
installer to perform the desired operations.
Feature #23 Factory Alarm Arm Output Functions
Factory Default Setting Arm Output
(press “arm/lock” button to program)
Options:
Parking Light Output (press “disarm/unlock” button to program)
Channel 4 Latch Output (press “II” button to program)
Channel 4 On Demand Output (press “III” button to program)
The default setting of this feature is to arm the factory alarm when the Excalibur
is armed. Other options for this output are a (-) Negative flashing parking light
output, and an additional remote output, operated by the transmitter’s “arm/
lock” and “II” buttons together, and in two forms of operation: “Latch”, in which
the output toggles (i.e.- turns on and turns off) with each buttons press, and “On
Demand” which is output occurring while the buttons are being pressed.
Feature #21 can change this channel’s button assignment.
Page - 34
The final 3 Programmable Features are for the installer’s use.
To Next Page
Loading...
