Tach Programming
Vehicle Learn (cont’d)
The vehicle’s tach signal must be learned for proper operation. After making the tach wire con-
nection, change installer feature #3 to “Tach WIre” & perform the following steps:
Step 1 Turn the ignition key “ON”
Step 2 Within 5 seconds, press the brake pedal 5 times. (the siren will chirp 5 times)
Step 3 Start the engine. The status lights will turn on indicating it has learned the current tach
signal. If it does not light, check your tach connection and start over.
Step 4 If the engine has a high idle at startup, it may be necessary to allow the idle to “settle” to
around 700 RPM. If needed, you can press the valet button 1 time to resample the tach signal.
The status light will ash off then back on once the signal has been resampled.
Step 5 Turn the ignition key “OFF”.
Step 1 Have all transmitters which are to operate the system at hand. Then, turn the ignition “on”.
Step 2 Within 5 seconds of turning on the ignition, press the Valet button 5 times. The horn will
briey sound & the status light will turn on, conrming that for the next 10 seconds the system is
ready to learn a transmitter/controller code.
Step 3 Press the “lock” button (press “start” on 1-button models) on each transmitter one at a
time. The system will chirp the horn once to conrm that each was learned. The transmitter’s other
button’s are automatically assigned at this point. If a code is not received within a 10 second
period, the learning process will end, as indicated by another horn honk.
Step 4 Turn the vehicle’s ignition “off”.
Programming Transmitters
A matrix of all programmable features and their options are on the next page. For feature
explanations, refer to the operation manual. Use the procedure below to make changes.
NOTE: You can program features via your computer with Omega Weblink.
Visit www.omegaweblink.com for more information
Step 1 Turn the ignition key “ON”, then “OFF”
Step 2 Within 5 seconds of step 1, press the valet button 5 times to access user features (Press
10 times to access installer features). (The siren/horn will sound and the status light will turn on)
Step 3 Within 10 seconds of step 2, press the valet button the number of times corresponding
with the desired feature’s number. (The siren/horn will chirp equal to the selected feature)
Step 4 4-button MODELS: Press the transmitter button that matches your desired setting.
1-button MODELS: Press the transmitter button (OR turn on the ignition and press the
brake pedal) the number of times that matches your desired setting. (The siren/horn will chirp
matching the selected setting)
Step 5 If you wish to change more features, repeat steps 3 & 4 at this time.
Step 6 To exit programming, turn the ignition key “ON” then “OFF”. Or, it will exit automatically
after 10 seconds of no activity.
RESTORING FEATURE SETTINGS TO FACTORY DEFAULT:
Step 1 Enter Intaller Feature programming (DO NOT SELECT ANY FEATURES)
Step 2 4-button MODELS: Press LOCK + UNLOCK (or BRAKE x 5)
1-button MODELS: Press the START button 5 times (or BRAKE x 5)
(The siren/horn will sound to indicate reset and exit programming)
Programming Features
Step 7: OPTIONAL: To enable Manual Transmission Reservation mode, release and
set the parking brake. (The BLACK/WHITE wire must be connected to the parking
brake.)
System should chirp/ash lights 1x.
Step 8: TO SAVE SETTINGS: Shut down RS by pressing the BRAKE pedal.
This disables VEHICLE LEARN (installer feature #2).
TO CANCEL/START OVER: Shut down RS by remote or input wire.
11
To Next Page
Loading...
