IF THE AUGER STOPS WORKING
11
Press [ON] button to start. When using
[ON] auger should rotate. Wait 2 to 3
seconds. Then press [REV] button. Repeat
this 2 to 3 times. Make sure the auger
stops completely after releasing the
button.
Note:
Even after following the directions
above, if the juicer still doesn’t work,
please unplug the power cord,
disassemble the chamber set and
clean it. Then try again.
Any other servicing should be performed
by an authorized service representative.
Press [Rev] button for 3 to 5 seconds,
then release. When the [Rev] button is
released, the auger will stop rotating.
Repeat this 2 to 3 times.
The [Rev] button
pushes the ingredients upward releasing
the food clog.
2
1
To Next Page
Loading...
