Omega OAL-100 - Pull Arm

Pull Arm:
-Install roller onto arm (5/32" allen)
-Install jumper wire to "hold open" motor
-Slide arm onto shaft, typically 90 to 105
degrees & tighten pinch screw
-Remove jumper wire so roller contacts door
-Roller needs to be vertically centered in track
-Fasten track to door (see diagram)
-Place end caps on the track
-Install safety washer & screw
-Adjust magnets; see "setting the magnets"
1 3/4"
center wheel
fasten pull track
to
door
fasten pull track to door
1 1/2" minimum
safety washer
arm
screw
roller
shaft
track
O M E G A A U T O M A T I C S 2 0 1 8
V 2 . 0