Omega OAL-100 - Hardware as Shipped; Safety Information; Safety Instructions; Safety Warnings

Inputs/Outputs:
Notes:
- Connecting terminals COM to ACT1 will activate the operator to open
- Push buttons, card readers etc will all wire the same
- Multiple inputs can be wired together
- Use 20 gauge wire
Push Buttons
Strike
Notes:
- use terminals LOCK & +24 to signal
strike
- use 20 gauge wire
Programming Functions Range Units Default
1. overload 50-99 % 50
2. activation delay 0-99 0.1seconds 0
3. back check 0-99 % 20
4. holding time 0-99 1.0 seconds 15
5. opening speed 10-70 % 50
6. closing speed 0-99 % 20
7. latching speed 0-99 % 5
8. hold open 0-1 on/off 0
9. power assist 0-1 on/off 0
10. reactivation 0-1 on/off 0
O M E G A A U T O M A T I C S 2 0 1
8
V 2 . 0