13
Operating Instructions
Full-automatic Programming
This function is used to start cooking after a certain period of time and for a certain duration. A time of up to
23 hours and 59 minutes after the current time of day can be set. Prepare the food for cooking and put it in
the oven.
1. Select the desired cooking function and the temperature using the control knobs.
2. Press “MODE” until you see “dur” symbol on the screen. The symbol “A” will
flash.
3. Select the desired cooking time period using the “+” and “-” keys.
4. Press “MODE” until you see “end” symbol on the screen. The time and the
symbols “A” will flash.
5. Select the desired finishing time using the “+” and “-” keys. “ ” symbol will
disappear. Add the cooking period to the current time of day. You can set a time
of up to 23 hours and 59 minutes after this.
6. The current time will reappear on the screen, and the symbols “A”, and will
remain illuminated.
The operating time will be calculated and the oven will automatically start. The “ ” symbol will reappear on
the screen so that cooking will finish at the set finishing time. When the timer reaches zero, the oven will
switch off, an audible warning will sound and the symbol “A” will flash. Turn both control knobs to the “0”
position and press any key to stop the sound. The symbol will disappear and the timer will switch back to
manual function. Press “MODE” for 2 seconds and the “A” symbol will disappear and the timer will switch
back to manual function.
Sound Adjustment
To adjust the volume of the audible warning sound, while the current time of day is displayed, press “+” and
“-” keys and the dot in the middle of the screen will start to flash. Press “MODE” to display current signal
sound. After this, each time the “-” button is pressed, a different signal will sound. There are three different
types of signal sounds. Select the desired sound and do not press any other buttons. After a short time, the
selected sound will be saved.
To Next Page
Loading...
