5
Installation Instructions
Electrical Connection and Safety
WARNING: The electrical connection of this appliance should be carried out by an authorised
service person or qualified electrician, according to the instructions in this guide and in compliance
with the current local regulations.
WARNING: THE APPLIANCE MUST BE EARTHED.
• Before connecting the appliance to the power supply, the voltage rating of the appliance
(stamped on the appliance identification plate) must be checked for correspondence to the
available mains supply voltage, and the mains electric wiring should be capable of handling the
appliance’s power rating (also indicated on the identification plate).
• During installation, please ensure that isolated cables are used. An incorrect connection could
damage your appliance. If the mains cable is damaged and needs to be replaced this should be
done by qualified personnel.
• Do not use adaptors, multiple sockets and/or extension leads.
• The supply cord should be kept away from hot parts of the appliance and must not be bent or
compressed. Otherwise the cord may be damaged, causing a short circuit.
• If the appliance is not connected to the mains with a plug, an all-pole disconnector (with at least
3 mm contact spacing) must be used in order to meet the safety regulations.
• The appliance is designed for a power supply of 220-240V ~ and 380-415V 3N~. If your supply
is different, contact the authorised service person or a qualified electrician.
• The power cable (H05VV-F) must be long enough to be connected to the appliance, even if the
appliance stands on the front of its cabinet.
• Ensure all connections are adequately tightened.
To Next Page
Loading...
