10
Operating Instructions
Main Oven Function Controls
Grill
It is indicated for grilling and gravitating small quantities of traditional food.
Maxi Grill
Function for grilling foods.
Fan Forced Maxi Grill
Important: do not set thermostat knob (C) to over 175C°. During grilling, keep the oven door
closed. All grill components and fan work. In this setting, the central heating elements of the top
work. This combination of features compulsory in the air in the oven for the entire cycle of
increased non-direct heating elements heat radiation effect. This will allow the heat to penetrate
the internal food, and avoid burning of the food.
Bottom heating Element with Fan
The air which is heated by the lower heating element is circulated by the fan and so helps to
distribute the heat between 50 and 200°C. This function can be used for sterilizing glass jars.
Accessories
It is recommended that you use the containers indicated depending on the food you will cook in your oven.
You can also use glass containers, cake pans and special oven trays suitable for use in your oven
(available in kitchenware shops). Pay attention to the information given by the supplier for use of this
cookware. The information given below should be implemented for enameled containers.
If the food to be cooked does not completely cover the oven tray, if the food is taken out of the deep-freezer
or if the tray is used to collect the dripping juices of the foods during the grill operation, deformation might
be observed on the tray over time due to high temperatures forming during the cooking/baking operation.
This is a normal, physical state that results during the heat transfer. Do not leave a glass tray or container in
a cold environment immediately after cooking in them. Do not place them on cold and wet surfaces. ensure
that they slowly cool off by placing them on a dry piece of cloth or wooden board, otherwise, the glass tray
or container might break. If you are going to use the large wire oven rack/grill, insert a tray into one of the
lower racks to collect fat or oil. To make cleaning easier, add some water into this tray. In a grilling
operation, use the shelf in position 4 or 5.
Each wire grid and tray comes with a built-in safety feature to help minimize them being accidentally pulled
fully out. This comes in the way of a “step”, positioned part-way in from the rear of the accessory. To fit
them into the oven, push the wire grid or tray part way into the oven until the step “catches”, then angle the
part over the step & fully insert. To remove, repeat the operation in reverse.
To Next Page
Loading...
