OMEX Shift Light Sequential - User Manual

OMEX
PERFORMANCE ELECTRONICS
Please ensure that you read this manual thoroughly before you install this unit. In conjunction
with this Shift Light, we recommend use of a high quality rev limiter, such as the Omex Rev
Limiter Clubman or Rev Limiter Clubman with Launch Control.
This unit is suitable for most 4-stroke petrol engines and most ignition types, including CDi
systems with tachometer output.
INSTALLATION
Ensure that the ignition is turned off before starting installation.
The unit is connected to the engine using the attached colour coded wires and the supplied
cable connectors.
BLUE WIRE Connect this to the coil negative (-) terminal
RED WIRE Connect this to the coil positive (+) terminal. If this is not easily accessible
then this wire can be connected to any positive feed that is switched by
the ignition switch.
BLACK WIRE Connect this wire to any good electrical connection on the car bodywork.
A self-tapping screw and spring washer are supplied for this purpose if no
bolt heads are within easy reach of the wire. It is essential that a good
quality connection is made.
Keep wires clear of hot or rotating parts using the supplied cable ties.
CDi IGNITIONS - Telephone our help line for specific instructions.
Distributorless Systems - Use the tachometer output from the ECU, or one of the coil
negative connections. For dual coil vehicles ALWAYS set the number of cylinders to two.
MOUNTING THE UNIT - Remove the backing from the adhesive pad on the back of the unit
and mount it to a clean, flat, grease-free surface. Keep the unit away from hot or exposed
areas. Ensure that the unit and all wires are kept as far as possible from the HT parts
of the ignition system.
MOUNTING THE LED MODULE - The LEDs have a narrow viewing angle so ensure that the
module is facing straight towards the driver. Mount the module using the supplied adhesive
pads.
‘+’ BUTTON
‘-’ BUTTON
COIL POSITIVE (+)
COIL NEGATIVE (-)
EARTH
RED
BLUE
BLACK
LED MODULE
LED 1
LED 2
+
LED 1
LED 2
OMEX
-
SHIFT LIGHT
SEQUENTIAL
SEQUENTIAL
OMEX
PERFORMANCE ELECTRONICS
K
o
K
VERSION
INSTALLATION
AND
USER INSTRUCTIONS
OMEX TECHNOLOGY SYSTEMS LTD
3 Mackenzie Way
Manor Road
Cheltenham
GLOS GL51 9TX
T: +44 (0)1242 260656 F: +44 (0)1242 578069
Email: info@omextechnology.co.uk
SHIFT LIGHT
INNOVATION RESEARCH DESIGN MANUFACTURE QUALITY
www.omextechnology.co.uk
72/245 - 95/54 - 1573 - 00
e
11
EUROPEAN TYPE APPROVED
2
OMEX
PERFORMANCE ELECTRONICS
OMEX
PERFORMANCE ELECTRONICS
+
1
SEQUENTIAL
SHIFT LIGHT

Summary

Installation Guide

Wiring Connections

Details on connecting the unit's coloured wires to the vehicle's ignition system and earth.

System Specific Connections

Instructions for connecting to CDI ignitions and distributorless systems for accurate tachometer input.

Mounting Instructions

Guidance on where and how to physically mount the main unit and LED module for optimal visibility.

Setting Up and Support

Setting the Number of Cylinders

Procedure to configure the unit for the correct number of engine cylinders.

Setting the Shift Point

Instructions on how to adjust the engine RPM at which the shift light activates.

Setting the LED Interval

Configuration of the RPM interval between sequential LED activation.

Customer Care and Warranty

Information on Omex's customer support, warranty, and product legal status.

OMEX Shift Light Sequential Specifications

General

Brand	OMEX
Model	Shift Light Sequential
Category	Automobile Accessories
Language	English