Need help?Do you have a question about the OMEX OMEM710 and is the answer not in the manual?
General| Brand | OMEX |
|---|---|
| Model | OMEM710 |
| Category | Automobile Accessories |
| Language | English |
Instructions on how to wire the semi-assembled or ready-built harness to the ECU.
Guidance on installing and setting up a trigger wheel for engine position sensing.
Directs the user to the software chapter for ECU connection and calibration.
Lists pre-mapping configuration steps like disabling non-essential functions and setting up sensors.
Advice on adjusting injector scaling for initial engine startup based on varying requirements.
Refers to the 'Sensor Setup' chapter for ignition timing alignment procedures.
Steps for mapping fuel and ignition, including disabling oxygen feedback and calibrating offsets.
Calibration of the throttle position sensor, including TPS min, max, and autozero settings.
Configuration of the MAP sensor for engine load sensing, including scaling and offset.
Setting the ignition timing specifically for the cranking phase of the engine.
Configuration of fuel delivery parameters for engine cranking.
How to add extra fuelling for rapid throttle movements and engine acceleration.
Using a narrowband oxygen sensor to trim fuelling for stoichiometric mixture.
How the ECU reacts to knock by retarding ignition and increasing fuel.
Using the Wastegate Duty map to control boost pressure via a PWM solenoid.
How anti-lag maintains boost and turbo speed by controlling torque with ignition and fuel cuts.
To Next Page
