OMEM710 Hardware Manual 2v11
31
9.1 Tacho
The frequency of pulses for the tacho is set by the option Tacho Teeth. Adjust this number until the
tacho reads the correct engine speed. The correct setting for a 4cylinder tacho is 3.
9.2 Shift Light
If using a single shift light engine speed for all gears then the engine speed at which the light is
turned on is set by the option Shiftlight On RPM;
9.3 Gear dependent shift light speed
For this control a road speed sensor must be fitted and calibrated, and gear recognition must be
calibrated.
To Next Page
Loading...
