86
arameters for the current preset:
aravalue> Sets a new value for the selected parameter.
er. The System Parameters are assigned to controls which govern
ysparas
lays the following table:
Input ource [A [0]
dB]
9) Pilot Level ['n/a'] 10) Phase Adjust ['n/a']
['
14) LED Source [0]
15) Backlight [70] 16) Contrast [50]
17) Headphones [-10.0dB] 18) Separation ['n/a']
) Pree hasis
27) Tilt Eq [None] 28) Tilt Freq [5]
29) HP Filter [OFF] 30) Meta ['n/a']
) Ave wer ['
Example: saveas BOOGY <enter> Commands the Omnia to save the current settings as preset BOOGY.
Non-System Parameters (paras)
paras Lists the modifiable parameters available for the current preset in a table format.
Example: paras <enter> displays the p
paravalues <index #> Lists all possible values for the parameter at the given index number.
Omnia-3 System Parameters
A 'syspara' is an Omnia-3 System paramet
overall operation, such as Input and Output Gains, Pre-emphasis/De-emphasis, etc. These parameters would
NOT be saved with individual presets, but instead are saved using the Save To Card option in the System menu.
To obtain a list of all System parameters, you use the command 'sysparas', which lists all of the adjustable
parameters in a table format with their current setting value in brackets. On the Omnia-3am typing s
<enter> disp
1) S ES/EBU] 2) Analog Gain
3) Input Left [0.0dB] 4) Input Right [0.0
5) Output Left [+4.0dB] 6) Output Right [+4.0dB]
7) SCA Level [-20.0dB] 8) Composite 1 [3.60 V]
11) Deemphasis n/a'] 12) Preemphasis ['n/a']
13) Analog Phase [1]
19) Editing Mode [EXPERT] 20) Current State [ENABLED]
21) Composite 2 [3.60 V] 22) Input Phase [NORMAL]
23 mp ['n/a'] 24) Ctrl Port Baud [19200]
25) Mono Mode [Stereo] 26) Asym Mod [100%]
31) LPF Freq [10kHz] 32) LPF Freq ['n/a']
33) BS412 ['n/a'] 34) Ref. Headroom ['n/a']
35 . Po n/a'] 36) WB AGC ['n/a']
37) Phase Rot. ['n/a']
A value of ‘n/a’ indicates that this parameter is not applicable to the am style.
To Next Page
Loading...
