Omnia 3

87
a
] 2) Analog Gain [0]
put [0.0
ft [+
-2
12) Preemphasis ['n/a']
RT] 20) Current State [ENABLED]
22
] 24
26
28
30
32
34
a'] 3
A value of ‘n is not
Setting Ne
To find the new value you wish to use for a particular Syspara:
syspara ndex #> Lists al parameter.)
Example: sy isplays a ta ft values.
To set a new
sy #>[<sysparaval
To reset all S o their factory
sy es the system attrib lts.
To save all S -panel memo
sy m attributes to the Omnia PC Card.
sysload Loads the system attributes from the currently inserted Omnia PC Card.
On the Omnia-3net/drm typing syspar s <enter> displays the following table:
1) Input Source [ANALOG
3) In Left dB] 4) Input Right [0.0dB]
5) Output Le 4.0dB] 6) Output Right [+4.0dB]
7) SCA Level [ 0.0dB] 8) Composite 1 [3.60 V]
9) Pilot Level ['n/a'] 10) Phase Adjust ['n/a']
11) Deemphasis ['n/a']
13) Analog Phase [1] 14) LED Source [0]
15) Backlight [70] 16) Contrast [50]
17) Headphones [-10.0dB] 18) Separation ['n/a']
19) Editing Mode [EXPE
21) Composite 2 [3.60 V] ) Input Phase [NORMAL]
23) Preemphasis ['n/a' ) Ctrl Port Baud [19200]
25) Mono Mode [Stereo] ) Asym Mod ['n/a']
27) Tilt Eq ['n/a'] ) Tilt Freq ['n/a']
29) HP Filter ['n/a'] ) Meta ['n/a']
31) LPF Freq ['n/a'] ) LPF Freq [16kHz]
33) BS412 ['n/a'] ) Ref. Headroom ['n/a']
35) Ave. Power ['n/ 6) WB AGC ['n/a']
37) Phase Rot. ['n/a']
/a’ indicates that this parameter applicable to the net style.
w Syspara Values
values <syspara i l the possible values for any
sparavalues 3 <enter> D ble listing the possible Input Le
value for a Syspara:
spara <syspara index ue index #>]
ystem parameters back t defaults:
sdefaults Restor utes back to their factory defau
ystem settings to the rear ry card.
ssave Saves the syste
To load the saved setting from the rear-panel memory card: