Need help?Do you have a question about the Omnitron Systems Technology Omnitron 8000-0 and is the answer not in the manual?
General| Protocols | IP, UDP, SNMPv1, SNMPv2c, SNMPv3, TCP, ARP, ICMP, Telnet, FTP, 802.3ah |
|---|---|
| Supported MIBs | RFC1155, RFC1156, RFC1157, RFC1212, RFC1213, OST MIB |
| Copper Connectors | RJ-45, DB-9 |
| Controls | UTP Crossover, Frontplane/Backplane |
| LED Displays | Pwr, Pwr Supply (3), Management Link, Master/Slave, Mgt Poll |
| Power Requirements | 0.32A @ 3.3VDC |
| Compliance | UL, CE, FCC, Class A, NEBS 3 |
| Operating Temp. - Standard - Wide Temp. Range | 0 to 50o C -40 to 60o C |
| Storage Temp | -40 to 80o C |
| Humidity (non-condensing) | 5 to 95% |
| Altitude | -100m to 4000m |
| MTBF (hrs) | 786, 000 |
Weight and Dimensions| Dimensions | W: 0.85" x D: 4.5" x H: 2.8" |
|---|---|
| Weight | 8 oz. |
Provides an overview of the Network Management Module's front panel management ports.
Details the Serial RS-232 Console Port for initial setup and configuration.
Explains redundant ports for daisy-chaining up to 19 chassis for single IP management.
Covers the backplane Ethernet port for In-Band management connectivity between modules.
Outlines the steps for installation and configuration of the NMM.
Explains the configuration of on-board switches for management modes.
Details the switch for configuring the device connected to the UTP management port.
Describes the switch for configuring In-Band or Out-of-Band management.
Provides instructions for physically installing the module and connecting the UTP cable.
Covers configuring IP address, subnet mask, gateway, and other control parameters.
Explains how to set the chassis number and name for identification.
How to set SNMP community names for read and write access.
Configuration of SNMPv3 security levels, usernames, and passwords.
How to enable or disable the SNMPv1/v2c agent.
How to enable or disable the SNMPv3 agent.
Configuring VLAN support for IP management using IEEE 802.1Q tags.
Details Remote OAM for IP-less management through IEEE 802.3ah channel.
How to access the NMM using SNMP management software like NetOutlook.
Instructions for accessing the NMM using Telnet client.
Provides information on the NMM via the Module status screen.
Introduces LED indicators and the troubleshooting approach.
Discusses problems related to the Power LED not illuminating.
Covers troubleshooting steps for the UTP link LED not illuminating.
To Next Page