OMP Hobby Edge 540 - Page 10

ElevatorAssembly
Ø ElevatorServoInstallation
1. Finda60‐coreextensioncableonthefuselage,tearoffthe
sticker,thenconnectitwithelevatorservo.
2. Findthewhitepolyesterthreadinthefuselageframe,gently
pullituntiltheservoisplacedintotheopenedservohole.
3. Runtheelevatorservoextensionwiresthroughtheconduit
locatedinsidethefuselageandthenplacetheextensionwires
intoframeholes.
4. Securetheservousingthescrews.
Ø HorizontalTailInstallation
1. Carefullylocatetheslotwhichhasbeenmadeon
horizontaltail,lightlycutthroughthecoveringbutnot
intothebalsasheeting.
ZhuhaiEdgeSmartDriveTechnologyCo.,Ltd.
www.omphobby.com