Wings Assembly
3. Pull out the white polyester thread from the servo hole with
tweezers, tie up with aileron servo connector.
Ø Aileron Servo Installation
1. Carefully locate the slot which has been made on the wing
tail, lightly cut through the covering but not into the balsa
sheeting.
2. Use sand paper to roughen the root of control arm. Try to
insert it into the mounting slot to adjust the position at first,
then take it out, apply glue to the slot and the root of the
control arm, insert it to the slot to secure it.
Zhuhai Edge Smart Drive Technology Co., Ltd.
www.omphobby.com
4. Find the other head of white polyester thread from wing side,
pull it until aileron servo is placed in servo hole.
To Next Page
Loading...
