To Next PageTo Next PageTo Previous PageTo Previous Page
Loading...How to fix synchronization error on Omron Servo Drives slave?
A synchronization error at a slave can occur if the distribution clock is not set correctly. Also, the servo task processing time exceeding the set period can be the cause. Review the program or servo frequency to adjust it, so that the servo task processing time does not exceed the period.
What to do if the link is not established for Omron Servo Drives?
If the link isn't established, the Ethernet cable may be broken or incorrect; replace it if necessary. Also, check the connectors on the Ethernet cable for disconnections or faults and reconnect them securely. Another potential cause is a failure within a slave in the EtherCAT network configuration; in this case, replace the faulty slave.
Why are my Omron Servo Drives EtherCAT communications not starting?
EtherCAT communications might not start due to several reasons. First, ensure that ECAT[0].Enable is set to 1 via the Terminal tab. Another reason might be a discrepancy between the EtherCAT network configuration in the Controller and the actual physical network setup. Also, inspect the Ethernet cable for any breaks or disconnections at any slave in the network and connect the Ethernet cable correctly. Finally, if the ECAT[0].error value is not 0, it indicates that some errors have occurred; check the ECAT[0].error value to identify and address them.
How to troubleshoot link not established on Omron CK5M-CPU1 1?
If the Ethernet cable is broken or the specified cable was not used, replace the cable. Also, reconnect the connector and make sure it is mated correctly. If a slave within the EtherCAT network configuration failed, replace the slave.
Why does a synchronization error occur at a slave on Omron CK5M-CPU1 1 Controller?
A synchronization error at a slave on your Omron Controller can occur if the distribution clock is incorrectly set. Review the settings. Also, if the servo task processing time exceeds the set period, review the program or servo frequency to adjust it so the processing time does not exceed the period.
How to troubleshoot 'link is not established' on Omron Controller?
If the link is not established on your Omron Controller, the Ethernet cable might be broken or not the specified type. Replace the cable if necessary. Also, check if a connector on the Ethernet cable used for EtherCAT communications is disconnected or faulty; reconnect it securely. A failed slave within the EtherCAT network can also cause this issue; consider replacing the slave.
What to do if EtherCAT communications do not start on Omron CK5M-CPU1 1 Controller?
If EtherCAT communications don't start on your Omron Controller, first, use the Terminal pane to run the command ECAT[0].Enable=1. Also, verify that the EtherCAT network configuration in the Controller matches the physical network configuration. Check that the Ethernet cable is correctly connected. Finally, examine the ECAT[0].error value for any error indications.
What to do if I see a watchdog timer error on my Omron CK5M-CPU1 1 Controller?
If the Omron Controller displays a watchdog timer error, check for noise intrusion in the FG, power supply, and communication lines, and apply appropriate countermeasures. If a momentary power interruption occurred, ensure a stable power supply with the rated voltage and frequency. If the issue persists, the Motion Controller may need to be replaced.
General| Model | CK5M-CPU1 |
|---|---|
| Series | 1 Series |
| Type | Controller |
| Power Supply | 24 VDC |
| Communication Ports | RS-232C |
| Operating Temperature | 0 to 55°C |
| Programming Language | Ladder logic |
