Omron H5CL Series - Specifications

H5CLH5CL
2
Specifications
Item H5CL-Aj (AC models) H5CL-ADj (DC models)
Mounting DIN track, surface, and panel mounting (common) Panel mounting
External connections Socket Screw terminals
Enclosure ratings Panel surface: IEC IP66 and NEMA Type 4 (indoors) when Y92S-29 rubber gasket is used.
Digits 4 digits (zero suppress method)
Max. time settings 9.999 s (0.001-s unit), 99.99 s (0.01-s unit), 999.9 s (0.1-s unit), 9999 s (1-s unit),
99 min 59 s (1-s unit), 999.9 min (0.1-min unit), 99 h 59 min (1-min unit), 999.9 h (0.1-h unit)
Display modes Up (increment) and Down (decrement) selectable
Input signals Start, gate, reset, and key protection
Input method No-voltage input: via NPN transistor or switching of contact
Operating modes A (signal ON-delay), F (cumulative operation) selectable
Reset Power reset (A (signal ON-delay) mode only), external, manual resets
Sensor waiting time 216 ms typ., 250 ms max. (Control output is turned OFF and no input is accepted during sensor waiting
time.)
External power supply 50 mA at 12 VDC (±10%) ---
Display 7-segment LEDs (12 mm high, red LEDs for the present value, and 8 mm high, green LEDs for the set value)
Memory backup EEP-ROM (overwritten 200,000 times min.), can store data for 20 years min.
Mounting DIN track mounting, surface mounting, and panel
mounting
Panel mounting
Approvals UL 508, CSA C22.2 No.14; conforms to EN61010-1
J RATINGS
Item H5CL-Aj (AC models) H5CL-ADj (DC models)
Supply voltage 100 to 240 VAC, 50/60 Hz 12 to 24 VDC (permissible ripple: 20%
(p-p) max.)
Operating voltage range 85 to 264 VAC, 50/60 Hz 10.8 to 26.4 VDC
Power consumption Approx. 10 VA Approx. 3 W
Start, reset, gate inputs Min. pulse width: 1 ms/20 ms (selectable, same for all three inputs)
Key protection input Response time: 1 s max.
Power reset Min. power opening time: 0.5 s, excluding F (cumulative operation) mode
Control output
Contact output SPDT, 3 A at 250 VAC, resistive load (cosφ =1); min. applicable load: 10 mA at 5/24 VDC
(P level, for reference value);
Transistor
output
NPN open collector, 100 mA max. at 30 VDC max., residual voltage 1.5 VDC max.