6
EN
4. Maintenance
4.1 Maintenance
To protect your monitor from damage, follow the directions below:
Changes or modifications not approved by the manufacturer will void
the user warranty.
4.2 Storage
• Keep your monitor in the storage case when not in use.
1. Remove the arm cuff from the monitor.
The air plug is firmly connected not to come off accidentally.
When removing the arm cuff from the monitor, pull the air plug in
a straight way from the air jack. It clicks during pulling out.
2. Gently fold the air tube into the arm cuff.
Note: Do not bend or crease the air tube excessively.
3. Place your monitor and other components in the storage case.
• Store your monitor and other components in a clean, safe location.
• Do not store your monitor and other components:
• If your monitor and other components are wet.
• In locations exposed to extreme temperatures, humidity, direct
sunlight, dust or corrosive vapors such as bleach.
• In locations exposed to vibrations or shocks.
4.3 Cleaning
• Do not use any abrasive or volatile cleaners.
• Use a soft dry cloth or a soft cloth moistened with mild (neutral)
detergent to clean your monitor and arm cuff, and then wipe them
with a dry cloth.
• Do not wash or immerse your monitor and arm cuff or other
components in water.
• Do not use gasoline, thinners or similar solvents to clean your
monitor and arm cuff or other components.
4.4 Calibration and Service
• The accuracy of this blood pressure monitor has been carefully tested
and is designed for a long service life.
• It is generally recommended to have the unit inspected every two
years to ensure correct functioning and accuracy. Please consult your
authorised OMRON dealer or local OMRON representative at the
address given on the packaging or attached literature.
Caution
DO NOT disassemble or attempt to repair this monitor or other
components. This may cause an inaccurate reading.
Caution
To unplug the air plug, pull on the plastic air plug at the base of the
tube, not the tube itself.
To Next Page
Loading...
