Omron MicroHAWK ID-40 - Page 17

11.2. SYSMAC Studio may display a warning message if the NJ/NX does not have a name. If you see the
warning shown below, click "Yes".
11.3. Once online, a yellow line will be drawn under the toolbar. Click the "Synchronize" button, which is
identied below.
11.4. The controller synchronization page will then be displayed. Verify that the checked options match the
settings shown below. Click "Transfer to Controller", circled in red, to download the current project to
the controller.
11.5. SYSMAC Studio may display the message seen below if you are using EtherCAT devices as in the
NJ301 project le. Click "Yes" to continue the transfer.
17