UNIT ASSEMBLY AND USAGE
1. Place the Omron CompAir
®
XL on a table or other flat, stable
surface. Be sure you can easily reach the controls when you are
seated.
2. Remove the Jet-Air™ nebulizer kit (nebulizer, mouthpiece and
air tubing) from the carrying case.
NOTE: Prior to initial operation, the nebulizer should be
thoroughly cleaned (Use steps 1-3 in the DISINFECTANT
procedure in the CLEANING AND STORAGE section
of this manual).
3. Gently twist the nebulizer to separate it into
two sections. Be sure the pick-up funnel is in
place in bottom section of nebulizer. Add the
correct amount of prescribed medication to
the nebulizer medication cup (bottom
section of nebulizer).
4. Gently twist the top and bottom sections
together to assemble the nebulizer. Be sure
the two sections fit securely.
6
To Next Page
Loading...
Need help?
General
