2. Preparation
5
EN
2.2
Setting the Date and Time
1. Set the monitor to the correct date and time before taking
a measurement for the first time.
Press the button.
2. Press the O/I START button to store the setting.
Notes:
• To reset the date and time, hold down the button while the power is off.
• If the batteries have been removed for 30 seconds or more, the date and time setting will
need to be reset.
• If the date and time are not set, “-:--” appears during or after measurement.
1)
2)
To Next Page
Loading...
Need help?
General
