Need help?Do you have a question about the Omron V1000 INVERTER and is the answer not in the manual?
General| Cooling Method | Forced air cooling |
|---|---|
| Input Frequency | 50/60Hz |
| Output Frequency | 0.1 to 400 Hz |
| Overload Capacity | 150% for 60 seconds |
| Protection | Overcurrent, Overvoltage, Undervoltage, Overheat, Short circuit |
| Communication | RS-485 |
| Ambient Temperature | -10°C to +50°C |
| Humidity | 5 to 95% RH (non-condensing) |
| Enclosure | IP20 |
| Power Rating | 0.4kW to 15 kW |
| Storage Temperature | -20 to +60°C (-4 to 140°F) |
Details design improvements for vibration resistance and heat dissipation.
Discusses production line improvements and low expected failure rates.
Explains increased output current capability and double rating performance.
Explains flexible mounting without overheating issues, saving panel space.
Highlights reduced installation time and cost due to screw-less terminal design.
Describes integrated filter benefits for installation cost and logistics.
Details software for configuration, monitoring, and troubleshooting drives.
Explains continuous adaptive tuning for motor speed stability.
Describes integrated dual safety inputs for faster motor disconnection.
Illustrates the main circuit and control circuit wiring for the inverter.
Explains the functions of power input and motor output terminals.
Describes the functions of signal and communication terminals.
Demonstrates safe stop functionality with a safety relay unit.
Helps choose part numbers based on power rating and duty cycle.
To Next Page