F-162 General-purpose Basic Switch Z
Note: 1. The pin plungers of reverse-type models are continuously pressed by the actuator levers with compression coil springs and the pin plung-
ers are freed by operating the levers.
2. The tip is made of resin.
Minimum Order Lot
The following models are available at the minimum order lot specified below. Orders must be placed per lot.
Basic Models (Drip-proof High-sensitivity Models)
Parallel Solder terminal Z-15GW255 --- ---
Screw terminal Z-15GW255-B Z-15GW2A55-B5V
Solder terminal Z-15GW227755 --- ---
Screw terminal Z-15GW227755-B Z-15GW2277A55-B5V
Solder terminal Z-15GM55 --- ---
Screw terminal Z-15GM55-B
Solder terminal Z-15GM2255 --- ---
Screw terminal Z-15GM2255-B
Solder terminal Z-15GM255 --- ---
Screw terminal Z-15GM255-B
Solder terminal Z-15GNJ55 --- ---
Screw terminal Z-15GNJ55-B
Actuator Basic model (drip-proof)
Standard Micro load
G (0.5 mm) H (0.25 mm)
Without drip-proof terminal
protective cover
With drip-proof terminal
protective cover
Without drip-proof terminal
protective cover
Hinge roller lever
Unidirectional short
hinge roller lever
Reverse hinge lever
(see note 1)
Reverse short hinge
roller lever (see note 1)
Reverse hinge roller
lever (see note 1)
Flexible rod (coil spring)
(see note 2)
Actuator Standard High-sensitivity Minimum order lot
G (0.5 mm) H (0.25 mm)
Short spring plunger Z-15GD55-B --- --- 10
Spring plunger Z-15GK55-B --- ---
Hinge lever Z-15GW4455-B
Z-15GW55
Z-15GW55-B
--- ---
Short hinge roller lever Z-15GW2255
Z-15GW2255-B
--- ---
Hinge roller lever Z-15GW255-B --- ---
Flexible rod (coil spring) Z-15GNJ55-B --- ---
Flexible rod (steel wire) --- --- Z-15HNJS55-B
Actuator High-sensitivity
H (0.25 mm)
Solder terminal Z-15HNJS55
Screw terminal Z-15HNJS55-B
Flexible rod (steel wire)
To Next Page
Loading...
