31
Legal Terms
Statement of Conformity
OMTech declares that this product is in compliance
with the requirements and provisions of Directive
RED 2014/53/EU and the RoHS directive 2011/65/
EU and (EU) 2015/863.
FCC Statement
This device complies with Part 15 of the FCC rules and with the FCC
radiation exposure limits set forth for an uncontrolled environment.
It should be installed and operated with at least 8 inches (20 cm) of
distance between any person and the laser tube. More distance may
be required for those with older pacemakers or similarly sensitive
medical equipment.
Disclaimer
Your Light may differ somewhat from those shown in this manual
due to options, updates, etc. Please contact us if your engraving
machine came with an outdated manual or if you have any other
questions.
Misuse or unauthorized modification of this device, in addition to
risking serious property damage and severe personal injury, may
also void its compliance with US and EU regulations and voids any
warranty either stated or implied.
These instructions are protected by international copyright
and cannot be legally reproduced, transcribed, electronically
transmitted, or translated into another language without the prior
written authorization of OMTech.
Disposal
Electrical products should not be disposed of with
household products. In the EU and UK, according
to European Directive 2012/19/EU for the disposal
of electrical and electronic equipment and its
implementation into national laws, used electrical
products must be collected separately and
disposed of at the collection points provided for
this purpose. Locations in Australia, Canada, and
the United States may have similar regulations.
Contact your local authorities or dealer for
disposal and recycling advice.
Troubleshooting
If you nd your engraver producing irregular images, begin by checking the belts’ tensioning, the bolts’ tightness, the frame’s cleanliness and
straightness, and the work area’s stability. If all of those are ne, simplify your design or use lower speed and acceleration values for your
current project by adjusting the $110, $111, $120, and $121 parameters. Never set them higher than the system’s 15,000 mm/min. maximum.
To Next Page
Loading...
Need help?
General
