Onan CCKB - Installation Guidelines and Components; General Installation Guidelines

INSTALLATION
GENERAL
Installations must be considered individually,
however, the following installation guidelines should
be followed. Installations must conform to local
building codes, fire ordinances and other local, state
or federal regulations. See Figure 1.
installation points to consider include:
1 Level mounting surface.
2 Adequate cooling air.
3. Adequate fresh induction air.
4. Discharge of circulated air.
5 Discharge of exhaust gases.
6 Eiectncai connections.
7 -ut-! connections.
8 Accessibility for operation and servicing.
9 Vibration isolation.
10 N o i s e levels.
Provide a location that is protected from the weather
and IS dry. clean, dust free and well ventilated. If
practical, install inside a heated building for protec-
tio*^ from extremes in weather conditions.
Permanent installations need a sturdy, level mounting
base of concrete, heavy wood, structural steel or
other sturdy support at least 12 inches (305 mm) high
to aid routine maintenance, operation and service.
Assemble the vibration isolators in the order as shown
in Figure 2. The spacer bushing prevents compres¬
sion of the snubber or upper rubber cushion. Two
CARRIAGE BOLT
SQUARE NUT
LOCK WASHER
FLAT WASHER
SNUBBER
GENERATOR OR
OIL BASE MOUNTING
FOOT
CUSHION
MOUNTING SPACER
BUSHING
FLAT WASHER
The aif discharge side of set requires 3 inches
(76 mm) clearance from wall to permit set to rock on
Its mounts; at least 24 inches (610 mm) clearance is
required around all other sides for service accessibili-
FIGURE 2. VIBRATION ISOLATOR
FIGURE 1. TYPICAL CCKB GENERATING SET INSTALLATION
4