■■■■
■■■■
24
Helpful Hints
Problem: Solution:
Red light does not Replace batteries with 4 fresh,
blink when you press new AAA alkaline batteries.
a key?
The ONE FOR ALL Make sure you are using new
does not respond after batteries and are aiming the
pressing a key? ONE FOR ALL at your device.
The ONE FOR ALL A) Try all the codes listed for
does not operate your your brand. B) Try the search
device(s)? method on page 11.
Your brand is not Try the search method on page 11.
listed in the ONE FOR
ALL code section?
When following the set- Did you use the Code Lock fea-
up instructions, the red ture? You must first unlock the
light on the ONE FOR code before entering a new code.
ALL only blinks once in- Follow the instructions on page
stead of twice after you 23 to do this.
enter a three-digit code?
The ONE FOR ALL You may be using the wrong
is not preforming code. Start the search method
commands properly? over again to locate the proper
code.
Press a key but get Hold MAGIC until the red
the wrong result? light blinks twice, then press
992 and the device key twice.
You will need to set up your
device again. Try the codes for
brand or the search method
on page 11.
You cannot control the Hold MAGIC until red light
volume feature of your blinks twice. Then press 993
Satellite, Cable Con- and VOL+. To set the
verter or TV/Video volume control back to TV
combination? (Punch Through), hold MAGIC
until the red light blinks twice
then press 993 TV.
Problems changing Enter the programme number
channels? exactly as you would on your
original remote.
Video not recording? As a safety feature on your ONE
FOR ALL, you must press the
Record key twice .
Scan does not work Make sure your original remote
on your device? had a programme +/- key.