Input Select Toggle (F Key)
WWW.ONEFORALL.COM 11
The F (Function) key is designed to select the input of
your HiFi. The Input Select Toggle allows you to use
the F (Function) key to cycle through your inputs.
If the F key is not changing the input:
Press and hold down MAGIC
until the light blinks twice (the
light will blink once then twice).
Press Programme -, Programme +,
Volume - (The light blinks twice).
The Input Select Toggle is now programmed.
Setting Up a CD Player, Mini-Disc Player or
Cassette Player
To program a CD Player, Mini-Disc Player, or Audio
Cassette Player use the following instructions.
Insert a CD, Mini-Disc, or Audio Cassette into the
appropriate player. Ensure that the output of your
Amplifier/Tuner is selected for the device that you
are going to program.
Press and release the CD, MD, or TAPE key.
Press and hold down MAGIC
until the red light blinks twice (the
light will blink once then twice).
Enter your 6-digit code
according to the chart below.
Codes are listed on pages 62-71.
The red light will blink twice.
VOL (+) = 1
VOL (-) = 2
CH (+) = 3
CH (-) = 4
Press PLAY to verify that you have
programmed the correct code.
1
2
1
2
3
4
To Next Page
Loading...
