Jumbo Universal Remote Control
Catalog #1526
User’s Guide
This universal remote allows user to easily see and push buttons to control TV, VCR, DVD, Cable
and Satellite receivers. The large buttons are very sensitive to touch and have different colors for
different group functions. If you cannot hit the buttons, jacks on the back allow you to plug in your
special ability switches. Easy to program, easy to use. Size: 18"L x 10"W x 2"H. Requires 2 AA
Batteries.
ν Please refer to the manufacturer’s instruction manual included for programming
directions for this remote, with the exception of Step #1: Installing the Batteries. Please
see below:
ν Installing the Batteries:
• You will not be placing any batteries directly into the “One For All” remote as this is
permanently affixed to the Jumbo Remote.
• Instead, please locate the battery compartment recessed in the back of the Jumbo
Remote.
• The battery compartment cover is secured with a small screw. Use a Phillips head
screwdriver to remove this screw and remove the cover.
• Insert the 2 AA batteries into the compartment paying careful attention to proper
battery polarity.
• Replace the compartment cover and re-secure it with the screw.
• Test the unit by pressing the ON/OFF button. The red indicator light should blink. If
not, change your batteries.
• All programming will be done through the remote’s keypad on the back of this unit.
When programming make sure none of the large buttons on the front become
activated or depressed, doing so will prevent programming of your device.
ν Volume Setting:
• To have control of your T.V. volume while running a DVD, VCR or CBL/SAT, you will
need to lock the Volume as described on pages 12 & 13 in the “One For All”
instructions. Press and hold SET button until the red light on the remote blinks twice,
then release. Enter 9-9-3 and then press T.V. key once the Red light will blink twice.
Now when you press Vol up, Vol down or Mute it will be controlled regardless of the
device you are controlling.
To Next Page
Need help?
General
