ν Switch Use:
• You can plug up to 13 separate switches to control the same functions as the large
buttons; this is done via the input jacks located on the front side of the unit.
ν Troubleshooting:
If you cannot get your Universal Remote to operate any of your devices, or it will not
perform commands properly:
• Make sure that your batteries are fresh and installed correctly (according to proper
polarity). *
• If you are using external switches with your remote, make sure they are plugged in
all the way, there should be no gaps. Test your switches on other switch adapted
devices, to rule out your switches as the source of the problem.
• Read the” One For All’s” troubleshooting section on page 15 of the guide for any
additional troubleshooting tips.
• Try ALL of the codes listed for your device. Many set-up codes may allow partial
functionality; however, only one code will operate your device correctly.
• Make sure that you are within 6-10 feet of your device, with the remote facing the
device, while programming. Make sure that you are within 15 feet of your device
when using your remote.
• If the red light on the remote control does not blink when you press a key, replace
the batteries with two (2) new AA alkaline batteries. Be sure to install paying close
attention to proper battery polarity. *.
• * NOTE: When you replace your batteries, or remove them for any reason, you must
re-install batteries within 10 minuets, or re-programming your remote will be
required. This is why it is important to write down the codes that work for your
devices and keep both these manuals in a safe place.
If you have any questions or technical problems with your Universal Remote, or any of our
products, please call our Technical Assistance Department:
(1-800-832-8697)
customer_support@enablingdevices.com
Enabling Devices & Toys for Special Children
385 Warburton Avenue
Hastings-on-Hudson, NY 10706
Telephone 914-478-0960 – Fax 914-478-7030
www.enablingdevices.com
To Next Page
Loading...
