One for All URC-4021 User Guide

14
2. Enter 9 - 9 - 3 and then press VOL▲ once. The LED will
blink four times.
3. Volume will again be independently controlled according
to its default states for all programmed devices.
CLEARING CUSTOM PROGRAMMING
The One For All 4 Device Universal Remote Control contains an Operational
Feature Reset
program.
If desired, you can use it to clear custom programming, except your setup
codes and reassigned device keys, and reset them to original factory set-
tings.Also see Restoring Factory Default Settings as below.
IMPORTANT: Executing this program will erase all your custom settings for
Power Macro, Favorite Channels, and Volume Lock.
1. Press and hold SET until the LED (red light) blinks twice,
then release SET.
2. Enter
9 - 8 - 0.The LED will blink twice. The remote control
will return to normal operation.
RESTORING FACTORY DEFAULT SETTINGS
The One For All 4 Device Universal Remote Control also contains a Factory
Reset
program that you can use to reset all custom settings and setup codes
to original factory settings.Also see
Clearing Custom Programming as above.
IMPORTANT: Executing this program will erase all your custom settings for
Power Macro, Favorite Channels, Volume Lock, Reassigned Devices, and all
device settings.
1. Press and hold SET until the LED (red light) blinks twice,
then release
SET.
2. Enter 9 - 8 - 1.The LED will blink twice. The remote control
will return to normal operation.
CTGAE4P 4021 manual booklet 5/24/04 12:10 PM Page 14

One for All URC-4021 Specifications

General

Brand	One for All
Model	URC-4021
Category	Remote Control
Language	English