One for All URC-7110 - Search Method for Device Setup; Initiating Search and Code Selection; Scanning and Storing the Code; Troubleshooting Search Method

8 WWW.ONEFORALL.COM
3
English
Instruction manual
r4FBSDI.FUIPE
r&YUSB'FBUVSFT
TFFNBOVBMPOPVSJOUFSOFUTJUF
r,FZ.BHJD¡- Allows you to program functions from your original remote control even when LOST or BROKEN.
r.BDSP- Allows you to send a sequence of commands with the press of a single key.



4
Find the code for your device in the Code list
(page 50 - 57). Codes are listed by device type
and brand name. The most popular code is
listed first. Make sure your device
is switched on (not on standby).
1SFTTBOEIPMENBHJDGPSTFDPOETVOUJMUIFCMVF-&%BOZ-&%TUBZTPO
Enter the 1st code listed for your
device type & brand (e.g. TV
Hitachi = 1576)
--> The CMVF-&%XJMMCMJOLtwice and
then switch off.
If your device does NOT switch off?
--> Please repeat steps 1 - 3 trying
the next code listed for your
brand.
If NOT successful?
--> Try the Search Method.
Congratulations! You should now be able to switch your device back ON
and control your device successfully.
1
Direct Code Set Up
Press POWER.
3 sec.
2
x2
฀฀฀฀฀฀฀฀