10 WWW.ONEFORALL.COM
Example: How to learn (copy) the “I/II (mono/stereo)“ function from your
original remote onto the “red key” on your ONE FOR ALL remote control.
2
Press 9 7 5.
Press and hold magic for 3 seconds until a mode indicator (Blue LED) stays lit.
--> The blue LED will blink twice.
3 sec.
Select the
corresponding
device e.g. TV
< select >
x2
3
x2
4
2 - 5 cm
First; Press the ”red” key.
The TV LED will flash rapidly.
ATTENTION: Place both remote controls on a flat
surface. Make sure that the ends you normally
point at your device are facing each other.
Align both remotes also in height
then;
Press the “I/II (mono/streo)” key.
The blue LED will blink twice to
confirm successful learning.
• If you want to copy other functions within the same mode, simply repeat step 4
pressing the next key you want to copy by learning.
• You can learn approximately 100 functions.
Press and hold the magic key for 3 sec. --> The blue LED will blink twice and
switch off.
1
3 sec.
5
The Learning Feature
(How to copy functions from your original working remote onto the ONE FOR ALL 4)
To Next Page
Loading...
Need help?
General
