WWW.ONEFORALL.COM 11
How to delete a learned function to obtain the original function?
1) Press and hold MAGIC for 3 seconds until a mode indicator (Blue LED) stays lit.
2) Press 9 7 6.
3) Select the corresponding device mode (e.g. TV).
4) Press the key to be deleted (e.g. red key) twice.
Congratulations! You successfully learned (copied) the “I/II (mono/stereo)”
function from your original remote control onto your ONE FOR ALL remote
control. NOW whenever you press the “red key” (in TV mode) you will obtain
the “I/II (mono/streo)” function.
“Combi Control” settings
(combination 1 ) --> control TV + SAT (see p. 111)
(combination 2 ) --> control TV + SAT + AMP (see p. 111)
(combination 3 ) --> control TV
„Combination 1“ is programmed automatically when you set up a TV and SAT.
In Combi Control the POWER key will switch ON/OFF all devices
within the activated Combi Control Setting – simply by pressing it
for 3 seconds.
E.g. within Combi Control combination 2 you can switch OFF your
TV, SAT and AMP by by pointing towards these devices and simply
press and hold the POWER key for 3 seconds.
Example) How to activate “Combination 2” (See the key pad configuration
on page 111).
By now you probably have set up the ONE FOR ALL remote to control all (or most of) your
devices. Wouldn’t it be convenient if you wouldn’t have to select a device type all the time.
You can make this possible with ONE FOR ALL Combi Control. Combi Control enables you
to control up to 3 devices simultaneously (e.g control TV + SAT simultaneously).
Press and hold magic for 3 seconds until a mode indicator (Blue LED) stays lit.
3 sec.
1
Press 2 (to select combination 2).
3
Press Combi Control.
2
ONE FOR ALL Combi Control
To Next Page
Loading...
Need help?
General
