For example,to enter the first GE VCR code (on
page 17),press 0twice,6 once, 0once,and then
SELECTonce.
If the code is entered correctly,you will see the
[SUCCESS]message.
6. Press EXIT to exit the programming mode.You will
see an [EXIT SETUP]message as the URC-9910
remote control returns to normal operation.
7. To verify the code works,aim the URC-9910 remote
control at the desired device,press its device key
once and then press POWERonce.The device should
turn off.If it does not respond,repeat steps 2
through 6,trying each code for your brand until you
find one that works.If it still does not work,try
Searching For Your Code on page 27.
NOTE: If the device does not have a
POWER
key, press the
(
Play
) key.
8. Repeat steps 1 through 7 for each device you want
to control.For future reference,write down each
working device code in the boxes below:
TVCode:
VCRCode:
DVDCode:
SATCode:
CBLCode:
RCVR/AMP
Code:
CDCode:
AUXCode:
Aux.Device
Type:________________________________
11
To Next Page
Loading...
