One for All URC-9910 - Page 48

Audio Receiver Functions
Press RCVR/AMP once to control your audio
receiver.
Press POWER once to turn on or off the
selected device (e.g,RCVR/AMP).
Use GUIDEto display your audio receiver’s
program guide or setup menu.
Use INFO to display the audio receiver’s
program information.
Use SELECTto set the surround sound.Use ▲
(or ▼) to adjust the volume higher (or lower).
Use (or ) to adjust the balance left (or
right).
Use VOL+ (or VOL-) to raise (or lower) the
audio receiver’s audio volume.
Press MUTEonce to turn the audio receiver’s
audio off or on.
Use CH+(or CH-) to select the audio receiver’s
next higher (or lower) station (if applicable).
Use PREV to change the radio band
(if applicable).
Use the keypad (1~ 9and 0) to
select audio sources (e.g.,1~ 10).If
the original remote control required
pressing an Enter key to change the
audio source,also press the ENTER
key after the source number (e.g.,
9-ENTER).
Press ENTER once after entering the source
numbers on some audio receivers.
Use TV/VIDto switch the audio receiver
between input and output.
continued on next page...
▲
▲
SELECT
S
U
R
R
O
U
N
D
S
O
U
N
D
61