Press ENTER once after entering the channel
numbers on some TVs.
Use TV/VIDto switch the TV’s input to view
TV or cable programs.
Use the transport keys to control
your cable converter’s VOD service
(ifapplicable).
Use SLEEPto activate your cable converter’s
sleep timer (not available for all devices).
After programming,press M1 ~ M3 once to
run a desired macro (see Using Macros on
page 34).
After programming,press L1 ~ L4
once to activate a learned function.
(See Using Learning on page 29.)
Use PIP to switch the Picture-In-Picture
feature on or off (if available on your TV).
Use MOVE to move the window picture
to different positions in the main picture.
Use SWAPto switch images and sound
between the main and window pictures.
After programming,use COM SKIPto skip
commercials on your cable converter.(See
Using Commercial Skip on page 48.)
Use to turn on or off the key backlight.
When this feature is activated,keys will
remain backlit for 5 seconds after the last key
press.In the setup mode,backlighting
will remain on for 30 seconds.
Use SET for all programming sequences.
65
To Next Page
Loading...
