1. Turn on your device (not on standby) and point the OFA remote towards it.
2. Hold down MAGIC until the LED blinks twice.
3. Hold down the digit for your brand and device as listed above (e.g. 6 for Samsung TV).
4. The remote will send Power every 3 seconds until your device switches off.
5. As soon as your device switches off, release the digit.
6. The LED will blink twice and go out. The remote should now operate your device.
If you find one or more keys do not work as you expect, start again at step 1 – the remote will start with the next code in the memory.
HOW TO SET UP YOUR REMOTE
B – SET UP BY CODE
If your brand is not listed in section A, you can set up your device by trying codes individually.
To do this:
1. Turn your device on (not on standby).
2. Locate the brand of your device in the code list (pages 74-77). Codes are listed by Device Type.
3. Hold down MAGIC until the LED blinks twice.
4. Enter the first 4 digit code listed for your brand (e.g. 4542 for an Aiwa TV).
5. The LED will blink twice and go out.
6. Now aim the remote towards your device and press the POWER key.
7. If the device turns off, your remote is ready to use. If not, repeat steps 3-6 with the next code in the list.
Some codes are quite similar. If you find that one or more keys do not operate as you expect, try again from step 3 with the next code in
the list.
LEARNING
Your One For All remote control can learn any function from any other working remote control.
This can be useful if you are missing one or more functions from your original remote control and would like to add them to the ONE FOR ALL.
You can also learn a complete device if you can’t find a code.
To learn, firstly make sure you have all your original remote controls to hand, and that they have working batteries in. To learn functions, the
original remote should be approximately 3cm from the OFA remote, pointing towards it as shown below:
1. Hold down MAGIC until the LED blinks twice.
2. Press 975 – the LED will blink twice.
3. Press and release the key you want to learn a function onto (for example the HOME key) – The red LED will blink
continuously.
4. Press and release the key on the original remote.
5. The LED will blink twice to indicate the key has been learned correctly.
6. Repeat steps 3 and 4 for each key you want to learn – remember you can learn from multiple remotes, but only one function per key.
To Next Page
Loading...
