OneAccess 1645 - ETH2;ETH3 SFP Interface

1645 Chapter 4
User manual Technical specifications
39
4.5 ETH2/ETH3 SFP interface
• 100 or 1000 Base X port
• INF-8074 and SFF-8472 compliant
• The following working modes are supported and/or can be forced:
- Full duplex 100 Mbps
- Full duplex 1000 Mbps
- Speed selection: by configuration only
• The following OA SFP modules are supported:
Description Rate (Mbps) Mode Fibre Distance (km)
SFP-100BASE-FX 100 MM 2FO 2
SFP-100BASE-LX15 100 SM 2FO 15
SFP-100BASE-LX50 100 SM 2FO 50
SFP-100BASE-BX10
1
100 SM 1FO 10
SFP-100BASE-BX20
1
1. Modules for single fibre must be used in pairs: BX at one side and BX-D at the other side
of the link.
100 SM 1FO 20
SFP-100BASE-BX40
1
100 SM 1FO 40
SFP-1000BASE-SX
2
2. Only Gbit Ethernet SFP modules can be used on versions with a Fibre SFP Gbit Ether-
net interface; do not use Fast Ethernet SFP modules in a Gbit SFP slot.
1000 MM 2FO 0,5
SFP-1000BASE-LX10
2
1000 SM 2FO 10
SFP-1000BASE-LX20
2
1000 SM 2FO 20
SFP-1000BASE-LX40
2
1000 SM 2FO 40
SFP-1000BASE-BX10
1,2
1000 SM 1FO 10
SFP-1000BASE-BX20
1,2
1000 SM 1FO 20
SFP-1000BASE-BX40
1,2
1000 SM 1FO 40