oneConcept V-15 - Radio Operation; Automatic Station Search; Accessing Saved Stations

23
EN
EQ
Press repeatedly to toggle pre-set equalizing (Classic - Pop - Jazz - Rock - EQ
off).
RADIO
Note: When searching for stations or listening to radio stations, no
frequency is shown on the display.
Automatic station search (FM Scan)
You can use the FM Scan function to automatically scan for new digital radio
stations and remove inactive stations.
Press and hold the PLAY / PAUSE / FM SCAN button on the stereo system or
on the remote control for 2 seconds to select [Scan]. The number of stations
found will be displayed during the automatic station scan. When the automatic
station scan is nished, the last station listened to will be tuned in. If the last
listened station is not available, the rst station in the alphabetical list is tuned
in.
To manually tune in a specic radio station, tap the
/ button on the
stereo or remote control repeatedly.
Calling up saved stations
If you are in radio mode, you can call up the stored radio stations by repeatedly
pressing the PRESET key on the stereo system or on the remote control. When
you access the preset stations for the rst time, [P01] blinks on the display.
Note: The clock and the radio stations must be reset if there is a power
interruption or power failure. When you turn on the radio again after a
power failure, [12:00] blinks on the display to remind you that the clock
must be reset. After you have reset the clock, start an automatic station
search again.