Onespace 50-LD0101 - Page 7

7 of 16
ASSEMBLY INSTRUCTIONS
STEP 2
Attach a left outer drawer roller (21a) to the left board (2) and a right outer drawer roller (21a) to the right board (3)
using small screws (C). Attach two rollers to the middle board (4), a right outer roller (21a) to the left side and a
left outer roller (21a) to the right side. Refer to drawing below for which holes in the roller to use.
Left Side
Right Side
FIFTH TO
LAST HOLE
SECOND
HOLE
21a, right
21a, left
21a, left
21a, right
C x 8
C
C
C