OneTouch FASTTAKE - Code Matching and Setting

9
Start with the meter turned off. Insert a
OneTouch
®
FastTake
®
Test Strip to turn on
the meter. All segments of the display
will appear followed by the date and
time. Next, the code number will appear
on the display for three seconds.
Compare the code number on the meter
display with the code number on the test
strip vial. If the two code numbers
match, you may begin testing. If they do
not match, follow Step 3. When you first
use the meter, three dashes (Q) will
appear, showing that there is no code
stored in the memory.
Match the Code Numbers.
STEP 2
Enter the Code Mode.
STEP 1
(Example)
(Example)
DCO_05244004A_OTFT_OB_US 6/30/03 10:38 AM Page 9