OneTouch Select PLUS User Manual

7
Batteries
110
2. Insert the new batteries
With the "+" side facing up
toward you, place each battery in
the compartment within the fold
of the plastic battery tab.
Push each battery in until it
snaps into the battery clasp.
Replace the battery cover by
sliding it upwards onto the meter.
If the meter does not power
on after you have replaced the
meter battery, check that the
battery is correctly installed
with the "+" side up. If the
meter still does not power
on, contact Customer Care.
Contact OneTouch® Customer
Care on 0800121200 (UK)
or 1800535 676 (Ireland)
80062253 (Malta) or 800 9074
(Iceland).

OneTouch Select PLUS Specifications

General

Measurement Range	20-600 mg/dL
Test Time	5 seconds
Coding	No coding required
Battery Life	Approximately 1000 tests
Memory	500 test results
Automatic Shutoff	2 minutes after last action
Battery	1 CR2032 lithium battery
Operating Conditions	10%-90% RH
Storage Conditions	10-90% relative humidity
Weight	Approx. 52.5 g (with battery)