OneTouch Select PLUS User Manual

3
Take a test
33
NOTE:
• Use only OneTouchSelect® Plus Test Strips.
• Unlike some blood glucose meters, no separate step to
code your OneTouch Select® Plus System is required.
• Make sure your meter and test strips are about the
same temperature before you test.
• Do Not test if there is condensation (water build-up)
on your meter. Move your meter and test strips to a
cool, dry spot and wait for the meter surface to dry
before testing.
• Keep test strips in a cool, dry place between 5°C and
30°C.
• Do Not open the test strip vial until you are ready to
remove a test strip and perform a test. Use the test
strip immediately after removing it from the vial,
especially in high humidity environments.

OneTouch Select PLUS Specifications

General

Measurement Range	20-600 mg/dL
Test Time	5 seconds
Coding	No coding required
Battery Life	Approximately 1000 tests
Memory	500 test results
Automatic Shutoff	2 minutes after last action
Battery	1 CR2032 lithium battery
Operating Conditions	10%-90% RH
Storage Conditions	10-90% relative humidity
Weight	Approx. 52.5 g (with battery)