oneup EDC LITE User Manual (English)

To Next Page

EDC LITE INSTALL INSTRUCTIONS

Assembly time, approximately 10-15 minutes. Difficulty: Easy.

Things You Will Need

1. OneUp EDC Lite Kit

2. 4mm Hex (Long Handle Required)

3. 5mm Hex

4. Mallet or Hammer

5. Ruler or Tape Measure

The EDC Lite Kit contains the following pieces:

1. OneUp EDC Multi-Tool

2. OneUp EDC Lite Carrier

3. OneUp EDC Lite Tool Clip

4. Star Nut Setter Bolt

5. EDC Lite Bolt

Need help?

Do you have a question about the oneup EDC LITE and is the answer not in the manual?

oneup EDC LITE Specifications

General

Lists the tools and parts required for the EDC Lite installation, including hex wrenches and a mallet.

Verifies steerer tube inner diameter and length requirements for fork compatibility, noting incompatible fork types.

Involves removing the top cap bolt and screwing in the star nut setter bolt 10 full turns without bottoming out.

Hammers the star nut setter bolt down until flush with the top cap counterbore, ensuring it stays straight.

Inserts the EDC Lite Top Cap/Carrier into the steerer tube, aligning the tool slot and ensuring the tube is burr-free.

Installs and tightens the EDC Lite Bolt using a 4mm Hex to secure the assembly and adjust headset preload.

Explains how to tighten the headset using the EDC tool's 4mm Hex while on the trail for adjustments.

Inserts the EDC Multi-Tool and its clip into the installed carrier, ensuring the tool is securely stored.

Details the correct installation of the EDC Lite Tool Clip onto the Multi-Tool, noting the arrow orientation.