To reduce the risk of fire, electric shock or injury;
Read all instructions before using this grinding machine.
WARNING:
Improper use of the grounding plug can result in a risk of electrical shock.
D
ANGER:
IMPORTANT SAFETY INSTRUCTIONS
PAGE 2
1) DO NOT leave the machine plugged in when not in
use. Unplug from the outlet when not in use and/or
before servicing.
2) Electric shock could occur if exposed to rain. Store
indoors.
3) This is NOT a toy. Close attention is necessary when
used around or near children.
4) Use only as described in this manual. Use only
manufacturer's recommended attachments.
5) Inspect all power cords for damage before oper-
ating the machine and DO NOT use with damaged
cord plug.
6) If the machine is not working as it should because it
has been dropped, damaged, left outdoors in the
weather, contact the manufacturer or authorized serv-
ice center.
7) DO NOT operate this machine in a wet environ-
ment.
8) DO NOT
handle the plug or operate with wet hands.
9) DO NOT plug any equipment into the machine
unless it is recommended by the manufacturer.
10) DO NOT
pull by cord, use power cord as a handle,
close a door on cord, or pull cord around sharp edges
or corners. DO NOT run machine over the cord. Keep
cord away from heated surfaces.
11) DO NOT unplug by pulling on cord. To unplug,
grasp plug, not the power cord.
13) DO NOT put any object into motor openings.
12) Before flipping the polishing deck assembly
back, unplug all power cord from the motor.
14)
Keep hair, loose clothing, fingers and all parts of
body away from moving parts.
15) DO NOT operate the machine without a vacuum
and the manufacturer’s filters in place.
16) DO NOT operate where anesthetics and oxygen
are used.
17) DO NOT use around flammable or combustible liq-
uids such as gasoline or use in areas where they may
be present.
18) Replace damaged or worn parts immediately with
genuine manufacturer equipment parts to maintain safe-
ty and protect your limited warranty.
19) The power source MUST be properly grounded.
If using a generator check the manufacturers
grounding instructions.
20) The electrical box panel MUST only be opened
by a licensed electrician or authorized service tech-
nician and the power cord MUST be unplugged.
21) When transporting the machine from one loca-
tion to another keep the machine on level ground.
22) Prior to operating this machine, ensure that the
proper voltage is established (480) 3 phase power,
minimum 30 AMPS.
23) Ensure proper machine rotation is established
with vacuum and motor assembly.
To Next Page
Loading...
Need help?
General